Mitsubishi Electric PURY-M200YNW-A1 Service Handbook page 386

[8-13 Parts Replacement Instructions (Outdoor Unit) ]
(11) Before removing the front heat exchanger, protect the surrounding electrical components and the pipe cover with a
recommended felt soaked in water, and then remove the braze from four areas. (See Figures 8 and 9.)
To remove the right and left rear heat exchangers, remove the braze from four areas. (See Figures 10 - 13.)
Brazed area
Removal of the front heat exchanger on a
high-efficiency model (Figure 8)
Brazed area
Removal of the left rear heat exchanger on
a high-efficiency model (Figure 10)
Brazed area
Removal of the right rear heat exchanger on
a high-efficiency model (Figure 12)
BS_08_L
Brazed area
Removal of the front heat exchanger on a
standard model (Figure 9)
Brazed area
Removal of the left rear heat exchanger
on a standard model (Figure 11)
Brazed area
Removal of the right rear heat exchanger
on a standard model (Figure 13)
119
chapter 8 -