Setting Up The Radio Link - Worcester DT10RF Instruction Manual

All manuals and user guides at all-guides.com
x 4
x 1
1
2
x 4
3
4
SET?
YES
B
C
8
FITTING & OPERATING INSTRUCTIONS FOR WORCESTER BOSCH
DT10RF PROGRAMMER & DT10RF OPTIMISING PROGRAMMER
8-716-106-652 issue c (01.05) UK
SETTING UP THE RADIO
LINK
Receiver set up:
The colon, CH and antenna symbols
should flash on the display
1 Press the 'set?' button 4 times
2 Press the 'OK' button once
3 Press the 'set?' button 4 times; 'Lrn'
and 'OFF' should be displayed
4 Press the '+' button so the display
shows 'ON' and a flashing antenna
symbol. The learn mode is now ready
to receive a signal from the transmitter
during the next 2 minutes.
Transmitter set up:
The transmitter must be at least 1 metre
away from the receiver before starting
this procedure:
5 Slide open battery compartments (B)
6 Remove insulator strips (C)
A
7 Replace the right hand battery
compartment (B) first followed by
the left hand battery compartment
D
SELECT
The display (D) then shows the room
temperature and automatically transmits
a signal to the receiver unit in the boiler
to establish a radio link.
8 When a radio link has been
established the display reverts back
to normal operation with the antenna
symbol shown
7
5
6
To re-establish the radio link; open both
battery trays until the transmitter display
goes blank, repeat steps 1 to 4 then
step 7 to transmit a set up signal to the
receiver. Repeat this procedure until a
link has been established.
If the radio link is lost the antenna,
colon and CH symbols flash on the
receiver display. The program defaults
to manual mode. Press the 'OK' button
to override and switch the heating ON,
press again to switch OFF.
5
SETTING UP THE RADIO
LINK