General Description; Scope Of Delivery; Function Description; Technical Specifi Cations - Parkside PSBS 240 C2 Translation Of The Original Instructions

The manufacturer shall not be liable for
damages caused by use other than for the
intended purpose or by incorrect opera-
tion.

General description

The illustrations can be found
on the front and rear fold-out
pages.

Scope of delivery

Unpack the equipment and check that it is
complete. Dispose of the packaging mate-
rial correctly.
- Appliance
- Transparent spark protection (
- Adjusting screw for spark protection
( 2) (1 cross-drive screw incl. spring
washer and washer as well as nut)
- 2 workpiece supports (
mounting material (2 star grip nuts
( 5/17), 2 screws, 2 washers,
2 toothed lock washers
- 2 x Grinding belt
(1 x P* 80, 1 x P* 120)
- Instruction Manual
* Grit size (of the grinding belt)

Function description

The bench grinder with belt sander is a
combined device equipped with a grind-
ing disc and an adjustable grinding belt.
The device is provided with a spark pro-
tection and protective hoods for the protec-
tion of the user.
For the function of the operating parts,
please refer to the descriptions below.

Summary

1)
6/18) with
Technical specifi cations
Bench Grinder
with
Nominal input voltage U ... 230 V~, 50 Hz
Idle power consumption ...........190 W (S1)
Power consumption P ..240 W (S2 30 min)*
Safety class .......................................... I
Mechanical rating ............................IPX0
Measurement idling speed n
Grinding disc
Outer diameter ...................
Bore hole .......................... Ø 12.7 mm
1 Spark protection (two-piece)
2 Adjusting screw for spark protec-
tion
3 Protective hood grinding disc
4 Engine housing
5 Star grip nut to install the work-
piece support grinding belt
6 Workpiece support grinding belt
7 Clamping lever grinding belt
8 Adjusting screw for belt run
9 Protective hood grinding belt
10 Grinding belt
11 Fixing screws for grinding disc
cover
12 Grinding disc cover
13 Bore holes for table mounting
14 On/off switch
14a On switch
14b Off switch
15 Fixing screws for grinding disc
cover
16 Grinding disc cover
17 Star grip nut to mount/adjust the
workpiece support grinding disc
18 Workpiece support grinding disc
19 Grinding disc
20 Upper (a) and lower (b) roller
belt sander ................... PSBS 240 C2
GB IE
.. 2980 min -1
0
Ø 150 mm
21