Power Connection; Test Run - Grizzly ULTIMATE 14" G0555 Owner's Manual

Power connection

After you have completed all previous setup
instructions and circuit requirements, the machine
is ready to be connected to the power supply.
To avoid unexpected startups or property dam-
age, use the following steps whenever connecting
or disconnecting the machine.
connecting Power
1. Turn the machine power switch OFF.
2. Insert the power cord plug into a matching
power supply receptacle. The machine is
now connected to the power source.
figure 25. Connecting power.
Disconnecting Power
1. Turn the machine power switch OFF.
2. Grasp the molded plug and pull it completely
out of the receptacle. Do not pull by the cord
as this may damage the wires inside.
figure 26. Disconnecting power.
model g0555/g0555p (mfg. Since 5/11)

Test Run

once the assembly is complete, test run your
machine to make sure it runs properly and is
ready for regular operation.
the test run consists of verifying the following:
1) the motor powers up and runs correctly, and
2) the safety disabling mechanism on the switch
works correctly.
if, during the test run, you cannot easily locate
the source of an unusual noise or vibration, stop
using the machine immediately, then review
Troubleshooting on Page 45.
if you still cannot remedy a problem, contact our
tech Support at (570) 546-9663 for assistance.
To test run the machine:
1.
make sure you have read the safety instruc-
tions at the beginning of the manual and that
the machine is set up properly.
2. make sure all tools and objects used during
setup are cleared away from the machine.
3. verify that the machine is operating correctly
by turning it ON.
— When operating correctly, the machine
runs smoothly with little or no vibration or
rubbing noises.
— investigate and correct strange or unusual
noises or vibrations before operating the
machine further. Always disconnect the
machine from power when investigating or
correcting potential problems.
-23-