Grizzly ULTIMATE 14" G0555 Owner's Manual page 21

10. thread the remaining m8-1.25 hex nut onto
the m8-1.25 x 80 positive stop hex bolt,
then thread the bolt into the trunnion so that
approximately 2" protrudes above the trun-
nion (see figure 15). this will allow the table
to rest approximately level when it is installed
during the following steps.
2"
figure 15. positive stop installed.
11. remove the aluminum table insert from
the center of the table and remove the
table pin from the end of the table slot (see
figure 16).
insert
figure 16. table insert and pin.
model g0555/g0555p (mfg. Since 5/11)
12. line up the blade with the table slot and move
the table around the blade until the blade is in
the center of the table, then turn the table 90˚
counterclockwise and rest it on the trunnions
so that the bolts protrude from the bottom of
the trunnions.
13. Secure the table by threading the (2)
table lock knobs onto the bolts, as shown in
figure 17.
figure 17. Securing table to the trunnion.
14. replace the table insert and pin removed in
Step 11. make sure the table insert sits flush
with the table surface.
pin
⁄ "-16
3
8
-19-