Adjusting Volume Of Loudspeaker; Adjusting Squelch; Transmitting; Selecting Output Power - Furuno FM-8800D Operator's Manual

1. OPERATIONAL OVERVIEW
1.2.3

Adjusting volume of loudspeaker

The VOLUME control adjusts the volume of the loudspeaker.
1.2.4

Adjusting squelch

The SQUELCH control adjusts the squelch threshold level. Adjust it so that white
noise heard in the loudspeaker just fades out. Perform this operation when no
traffic is being received. AUTO squelch automatically reduces white noise.
Usually select the AUTO position. Avoid turning the squelch too far clockwise —
you may miss a long distance communication.
Note: To obtain correct scan watch/dual watch response, adjust the SQUELCH
control precisely.
1.2.5

Transmitting

Press the PTT (Push-to-talk) switch on the handset or microphone to talk, and
release it to listen for the response. The VHF section keyboard accepts no key
input when the PTT switch is operated.
Remarks on transmitting
Before transmitting, think about the subjects which have to be communicated
and, if necessary, prepare written notes to avoid unnecessary interruptions
and ensure that no valuable time is wasted on a busy channel.
Listen before commencing to transmit to make certain that the channel is not
already in use.
1.2.6

Selecting output power

After pressing the SHIFT key, each press of the 0 HI/LO key selects high or low
output power. Also Hi or Lo appears on the screen depending on your selection.
The transmitter power is automatically set for low on the following channels:
International: CH15, CH17, CH75, CH76
USA:
1.2.7

Turning the loudspeaker on/off

To turn the loudspeaker on/off, press the SHIFT key, then the 1 key. The
loudspeaker off mark appears when the speaker is off. The loudspeaker is
automatically turned off when the handset is used.
1-8
CH13, CH17, CH67, CH77; to operate USA channel 13 or 67 in
high power, keep HI/LOW key pressed while talking into the
handset.