Operating Voltage (Ac Mains) - QSC RMX Series User Manual

1
3
Outlets • Prises de courant • Netzanschluß • Tomas de corriente
120V
2
#10 AWG (3.5 mm) Stranded maximum
4
220–240V
C O N N E C T I O N S
Binding post outputs
1. Strip back insulation not more
than 13 mm (½ inch).
2. Insert wire fully so that none of
the conductor is exposed; tighten
barrel (use coin if necessary).
3. Non-European models only.
4. Spade lugs must have insulated
barrels to prevent electric shock.
WARNING: To prevent electric
shock, do not operate the ampli-
fier with any of the conductor por-
tion of the speaker wire exposed.
Connections for stereo and parallel
operations
Connections for bridged mono
operation. See bridged mono
operating precautions on page 11.
SPEAKER CABLING
Larger wire sizes and shorter lengths
minimize both loss of power and
degradation of damping factor. Do
not place speaker cables next to
input wiring.
Operating voltage
(AC mains)
Make sure you connect the amplifier
to the correct AC line voltage, which
is shown on the serial number label.
Connecting to the wrong line voltage
is dangerous and may damage the
amplifier.
C O N
Borne
1. Dénud
13 mm
2. Insére
qu'au
ne so
du co
de mo
3. Modè
4. Les co
avoir u
préve
électr
AVERTIS
les risqu
pas utili
portion
haut-pa
Connexio
modes st
Connexio
ponté mo
précautio
branche-
page 11.
CÂBLAG
Les câble
courtes d
fois les p
dégradat
d'amortis
les câble
proximité
Tensio
(alime
Vous dev
l'amplific
alternatif
qu'indiqu
de série.
courant a
et pourra