Navigator Setup; Navigation Data Source - Furuno NAVNET GD-1920C Operator's Manual

7. CUSTOMIZING YOUR UNIT
5. Rotate the ENTER knob to select a main screen, then press the ENTER knob. For
example, select the radar display. Your choice is then shaded to show that is has been
selected.
Hot page setup menu, SPLIT X 3 screen, sub screen selection
6. Rotate the ENTER knob to select the screen to show at the top right 1/4 screen, then
press the ENTER knob or the ENTER soft key.
7. Rotate the ENTER knob to select the screen to show at the bottom right 1/4 screen,
then press ENTER knob or the ENTER soft key.
Note: The SELECT WINDOW soft key functions to select the window to process.
8. Press the MENU key to close the menu.
7.7

Navigator Setup

This section provides the information necessary for selecting the type of navigator
connected to your plotter.

7.7.1 Navigation data source

The NAV SETUP menu mainly selects the source of
nav data. For GPS receiver other than the
GP-310B/320B, speed averaging and local time
offset (to use local time) are also available. Press the
MENU key followed by the SYSTEM
CONFIGURATION, NAV OPTION and NAV
SOURCE SETTINGS soft keys to display this menu.
7-22
HOT PAGE 1
PLOTTER
RADAR
COMPASS HIGHWAY
SOUNDER
Sub screen
EXT VIDEO
POSITION SOURCE
SPEED SOURCE
TEMPERATURE SOURCE
DE`PTH SOURCE
STW CALIBRATION
TEMP CALIBRATION
DEPTH CALIBRATION
WIND AVERAGING
WIND DIRECTION OFFSET
WIND SPEED CALIBRATION 00
NAV
ALL
SETUP
ETR
ETR
EDIT
ETR
0%
°
+0.0 F
+0.0ft
RETURN
5 minutes
°
P0.0
°
F