Furuno NAVNET GD-1920C Operator's Manual page 189

7. CUSTOMIZING YOUR UNIT
Displaying Loran C TDs
1. Select GRI, then press the EDIT soft key to show the GRI & station pair window.
GRI & STATION PAIR
▲
9940 11-27
▼
U.S. WEST COAST
Loran GRI & station pair window
2. Adjust the Trackball upward or downward to select GRI code.
3. Roll the Trackball rightward to show the display below, to enable selection of station
pair.
GRI & STATION PAIR
▲
9940 11-27
▼
U.S. WEST COAST
Loran C GRI & station pair window
4. Adjust the Trackball vertically to select station pair.
5. Press the ENTER soft key to register your selection.
6. If necessary, you may enter a position offset to refine Loran C position accuracy. Select
(GRI) CORRECTION 1 or CORRECTION 2, then press the EDIT soft key. Enter
correction value with the Trackball and alphanumeric keys. Use the +
switch from plus to minus and vice versa. Press the ENTER soft key or push the ENTER
knob.
7. Press the RETURN soft key twice.
8. Press the GENERAL SETUP soft key followed by the NEXT PAGE soft key.
9. Select "LORAN C" from "TD DISPLAY" and "TD" from "POSITION DISPLAY."
10. Press the MENU key twice to close the menu.
Displaying DECCA TDs
1. Select CHAIN, then press the EDIT soft key to show the chain & station pair window.
CHAIN STATION PAIR
▲
01 R-G
▼
S BALTIC
Decca chain and station pair window
7-28
- soft key to
< − −>