Track Test (Simulation Display); Outputting Target Data - Furuno FR-1500 Operator's Manual

2.12 Track Test (Simulation Display)

Do this test when the radar is not being used.
The simulation display tests the ATA processor for proper operation. The figure below shows
the starting picture of the simulation display. Each mark moves as time passes. Check that
each target's data is reasonable.
1. Press [MENU], [7], [7], [0], [0], [4], [4].
2. Press the [ENTER/SELECT] key to start the test.
3. It takes approximately three minutes for all vectors to be displayed completely on the
screen. The simulation display does not need radar, gyrocompass nor speed log input;
seven targets on various courses and speeds are provided.
Target Course
Target A 90.0°T
Target B 0.0°T
Target C 180.0°T
Target D 216.5°T
Target E 273.5°T
Target F 180.0°T
Target G 24.6°T
4. The simulation continues for five minutes and then repeats. To quit the test sequence,
repeat step 1.

2.13 Outputting Target Data

Target data may be output to external equipment as follows:
1. Press [MENU], [7], [7], [0], [0].
2. Press the [6] key to select OFF, REL, TRUE from the TTM field as appropriate.
1. Press the [ENTER/SELECT] key followed by the [MENU] key.
Speed CPA
(kt) (nm)
10.0 1.0
0.0 4.0
10.0 1.7
23.8 0.9
14.2 6.0
20.0 0.0
15.6 4.0
TCPA
(min)
10.4
310
300
-
290
28.2
280
15.0
270
22.5
260
250
30.0
240
43.6
230
220
-2.13-
000 010
350
020
340
330
320 F
C
A
B
XX
G
210
200
160
190
170
180
030
040
050
060
E
070
D
080
090
100
110
120
130
140
150