Furuno DRS4A Installation Manual page 21

5
3. Insert wires of cable M12-05BFFM (φ6) or CB-05BFFM (φ10) to the NMEA connector inside the
radar sensor, consulting the label on the connector for location. As for shield, use the cable
clamp shown below to fasten it to the RF chassis.
Cable
Clamp Use the clamp in the plastic bag supplied
inside the radar sensor.
15
Shield
370
Wind vinyl tape.
(supplied)
65
20
15 (Area fastened with the cable clamp)
Fabrication of CB-05BFFM cable
M12-05BFFM (φ6)
Cable clamp
(Face projecting part down.)
CB-05BFFM cable
Fasten the cable tie (supplied) within
15 mm from the end of vinyl sheath.
CB-05BFFM cable
Use the clamp supplied with the optional gasket
(Type: OP03-203, Code No.: 001-025-290)
Zoom up
Attach the cable clamp
using this screw.
14
CB-05BFFM (φ10)