Furuno IF-NMEASC Operator's Manual page 5

Safety instructions for the installer
WARNING
Turn off the power at the switchboard
before beginning the installation.
Fire or electrical shock can result if the
power is left on.
Do not install the equipment where it
may get wet from rain or water splash.
Water in the equipment can result in fire,
electrical shock or damage to the equipment.
Be sure that the power supply is
compatible with the voltage rating of the
equipment.
Connecting an incompatible power supply
can cause fire or damage the equipment.
The voltage rating appears on the inlet
of power.
Do not connect this unit to
NMEA 2000 bus.
It is intended for one-to-one connection
with the SC-30. Connection to an
NMEA 2000 bus can result in network
trouble and, in the worst case, fire.
Do not open the equipment.
Only qualified personnel should work
inside the equipment.
CAUTION CAUTION
Observe the following compass safe
distances to prevent interference to a
magnetic compass:
IF-NMEASC
Warning labels are attached to the equipment.
Do not remove these labels. If a label is missing
or illegible, contact a FURUNO agent or dealer
.
about replacement.
WARNING
To avoid electrical shock,
do not remove cover. No
user-serviceable
WARNING
To avoid electrical shock,
do not remove cover.
No user-serviceable parts
inside.
iii
SAFETY INSTRUCTIONS
Standard Steering
compass compass
1.05 m 0.70 m
Name: Warning Label (1)
Type: 86-003-1011-1
Code No.: 100-236-231
parts
Name: Warning Label (2)
Type: 86-129-1001-1
Code No.: 100-236-741