Furuno MARINERADAR FR-8122 Installation Manual page 31

View Position: Choose the operating position for this radar among Left, Left-Center, Center,
Right-Center and Right to view echo colors correctly. The default setting is Center.
Left: When operating this radar at the left side.
Left-Center: When operating this radar at the left-center side.
Center: When operating this radar at center position.
Right-Center: When operating this radar at the right-center side.
Right: When operating this radar at the right side.
Approx. angle of the view position as follows.
Note: The radar echo and trail echo are adjusted by the View Position. The
characters are not adjusted. This setting is also reflected on an external monitor
(option).
Input Source: Choose the input source between Main and Sub. The default setting is Main.
Main: When using this display unit as main radar.
Sub: When using this display unit as sub display. For Sub, the "Video Initial
Antenna Height: Set the height of the antenna above the water surface among 5, 10, 15,
20, 30, 40 and 50 m. The default setting is 15 m.
Antenna Rotation: "Rotate," the default setting, stops transmission when the antenna is
not rotating. "Stop" transmits radar pulses without rotating the antenna.
Local Time Offset: To display local time on the screen, set the time difference from the
Memory Clear: Restore the default settings. However, Purpose, Type, View Position and
Input Source are not restored.
Heading Adjustment
You have mounted the antenna unit facing straight ahead in the direction of the bow.
Therefore, a small but conspicuous target dead ahead visually should appear on the
heading line (zero degrees).
In practice, you will probably observe some small error on the display because of the
difficulty in achieving accurate initial positioning of the antenna unit. The following
adjustment will compensate for this error.
1. Set ship's heading toward a suitable target (for example, ship or buoy) at a range
between 0.125 and 0.25 nautical mile.
LCD screen
30°
Left
15°
Left-Center
Adjust" is required (page 3-6).
UTC.
3. SETTING UP THE EQUIPMENT
0° 30°
Center
Right
15°
Right-Center
3-3