Furuno MARINERADAR FR-8122 Installation Manual page 22

1. MOUNTING
Flush mounting
1. Prepare a cutout in the mounting location whose dimensions are as shown below.
2. Detach two rubber cushions from the display unit.
3. Insert the flush mounting sponge and four threaded rods from the rear side of the display
unit, and then set the display unit to the mounting location.
4. Fix the display unit by using four wing nuts from the rear side of the display unit.
Flush mounting sponge
1-14
Detach two rubber cushions.
Threaded rod
Wing nut
Flush mounting of display unit
4-φ5
282±1.0
303±0.5
CUTOUT DIMENSIONS