b) Run the signal cable as shown below.
c) Fix the signal cable with cable clamp as shown below.
11. Release the stay and close the cover. Loosely fasten the antenna bolts; you will have to
make some adjustments inside after completion of wiring.
Note: When closing the cover, set the gaskets to grooves in the bottom chassis, then
tighten bolts.
Cable clamp
RTB board cover
BOTTOM
CHASSIS
GROOVE
GASKET
ANTENNA BOLT
.
Torque : 9.8 ±0.1 N m
1. MOUNTING
Top view
1-11