Clearance For Service Access; Preparing A Good Foundation - Cal Spas LES Owner's Manual

Special edition

Table of Contents

2.2 Clearance for Service Access

While you are planning where to locate your spa, you need to determine how much access you will need for

service.

All spa models require a minimum of three feet / one meter access to

all sides of the spa for potential service. For this reason, the spa should

never be placed in a manner where any side is permanently blocked.

Examples include placing the spa against a building, structural posts

or columns, or a fence.

Spa models require access to all sides in case they need service or

repair. See the figure to the right.

If you are planning to enclose or surround your spa with a deck, make

sure there is easy access for service or repair.

NOTE: Spas require clearance on all sides of the spa.

NOTE: We strongly recommend that a qualified, licensed contractor prepare the foundation for your spa.

Damage caused by inadequate or improper foundation support is not covered by the warranty. It is the

responsibility of the spa owner to provide a proper foundation for the spa.

Your spa needs a solid and level foundation. The area that it sits on must be able to support the weight of the

spa, with water and occupants who use it. If the foundation is inadequate, it may shift or settle after the spa is in

place, causing stress that could DAMAGE YOUR SPA SHELL AND FINISH. Place the spa on an elevated 3 to 4" / 30

cm concrete slab. Pavers, gravel, brick, sand, timbers or dirt foundations are not adequate to support the spa.

If you are installing the spa indoors, pay close attention to the flooring beneath it. Choose flooring that will not

be damaged or stained. If you are installing your spa on an elevated wood deck or other structure, it is highly

recommended that you consult a structural engineer or contractor to ensure the structure will support the

weight of 150 lbs per square foot (732 Kg/m

3 feet / 1 meter

3 feet /

1 meter

3 feet / 1 meter

3 feet /

1 meter

3 feet / 1 meter

3 feet /

1 meter

3 fe

Table of Contents