Cal Spas LES Owner's Manual page 14

Step 4. Step 4.
Turn on power to the spa.
When the spa is filled to the correct level, turn on the power at the GFCI breaker. (Ensure that the 120V spas are
connected to the proper electrical outlet.)
Step 5. Step 5.
Prime the pump. (NEO system)
The system will enter the priming mode. Priming Mode will display on the control panel. In Priming Mode, all
devices such as jets and lights are operable. Jets can be turned on and off to help prime the pump. The system
will exit Priming Mode and go to the Main display when the RETURN button is pressed, or after four minutes of
inactivity.
Step 6. Step 6.
Install the filter into the filter canister.
NOTE: Make sure the filter has soaked at least 30 minutes before you install it. Insert the filter all the way
and screw it in. Do not over-torque the cartridge during installation, just hand tighten gently.
Step 7. Step 7.
Adjust water chemistry.
Test and adjust the water chemistry. See the section on page 29 for instructions on water clarity.
Step 8. Step 8.
Let the spa heat up.
When the spa has finished priming the heater will activate. Put the cover on and let the spa heat to the set temp.
13