Zoom F8n Pro Operation Manual page 239

5.
Use a USB cable to connect the F8n Pro and the computer.
NOTE:
• Use a USB cable that supports data transfer.
• The F8n Pro cannot operate on USB bus power. Use the internal batteries, the dedicated AC adapter or
an external DC power supply to power it.
• "Audio Interface with Rec" cannot be used with the following settings and functions.
- Sampling rate settings other than 44.1/48 kHz
- "SD Card Reader"
- "Audio Interface"
(→Using the
- FRC-8
• When "Audio Interface with Rec" is set to "On", the sampling rate cannot be changed.
sampling rate (Sample
• When "Audio Interface with Rec" is set to "On", files with sampling rates that differ from the F8n Pro
setting cannot be played.
• When "Audio Interface with Rec" is set to "On", "WAV Bit Depth" cannot be changed.
depth (WAV Bit
• Set the input source to USB1–4
(→Setting signals sent to headphones (Headphone Routing)
routing
outputs (MAIN OUT
sound played back from the computer.
• When "Audio Interface with Rec" is set to "On", the F8n Pro latency will increase 2 ms. When monitoring
sounds being recorded with a mic in real-time, increased latency can cause interference between sound
transmitted through the air from the source and the delayed monitored sound, possibly making accurate
monitoring of the sounds difficult.
• The operation mode for audio interface is changed depending on the "WAV Bit Depth" setting.
WAV file bit depth (WAV Bit Depth)
- "16-bit Linear"/"24-bit-Linear": The bit depth during use as an audio interface is set to 24-bit Linear.
- "32-bit Float": The bit depth during use as an audio interface is set to 32-bit Float.
USB (Mini-B)
(→Exchanging data with a computer (SD Card
(→Using as an audio interface (Audio
FRC-8)
Rate))
(→Setting the sampling rate (Sample
Depth))
(→Setting the input source (Input
Routing), Selecting signals sent to the sub outputs (SUB OUT
)
(→Setting the sampling rate (Sample
Reader))
Interface))
Rate))
Source)) or set USB1–4 to the output
Selecting signals sent to the main
、
239
Rate))
(→Setting the
(→Setting WAV file bit
Routing)) to monitor
(→Setting