Table of Contents
Advertisement
ANSI Z535.5 DEFINITIONS
• DANGER – Indicate[s] a hazardous situation
!
which, if not avoided, will result in death or
serious injury.
!
• WARNING – Indicate[s] a hazardous situation
!
which, if not avoided, could result in death or
!
serious injury.
!
• CAUTION – Indicate[s] a hazardous situation
!
which, if not avoided, could result in minor or
!
moderate injury.
!
• NOTICE – Not related to personal injury – Indicates[s]
situations, which if not avoided, could result in damage
!
to equipment.
The information contained in this document is the property
of Hussmann Corporation and shall not be used in whole
or in part without written permission.
This manual was written in accordance with originally
prescribed equipment that is subject to change. Hussmann
reserves the right to change all or part of the
equipment for future stores such as, but not limited
to, controllers and electrical specifications.
Do not use mechanical devices or other means to
accelerate the defrosting process.
Do not use electrical appliances inside the food
storage compartments of the case(s).
Case ventilation openings must be clear of any
obstructions. Do not damage the refrigerant circuit.
BEFORE YOU BEGIN
Read these instructions completely and carefully.
PERSONAL PROTECTION EQUIPMENT (PPE)
Only qualified personnel should install and service
this equipment. Personal Protection Equipment
(PPE) is required whenever installing or servicing this
equipment. Always wear appropriate PPE as required
by OSHA regulations, as well as all other federal,
state and local codes. PPE may include, but is not
limited to, safety glasses, gloves, protective boots or
shoes, long pants, and a long-sleeve shirt. Observe
all precautions on tags, stickers, labels and literature
attached to this equipment.
Proper Field Wiring and Grounding Required!
Failure to follow code could result in death or serious
injury. All field wiring MUST be performed by qualified
personnel. Improperly installed and grounded field
wiring poses FIRE and ELECTROCUTION hazards. To
avoid these hazards, you MUST follow requirements
for field wiring installation and grounding as described
in NEC and your local/state electrical codes.
— LOCK OUT / TAG OUT —
To avoid serious injury or death from electrical shock,
always disconnect the electrical power at the main
disconnect when servicing or replacing any electrical
component. This includes, but is not limited to, such
items as controllers, electrical panels, condensers,
lights, fans, and heaters.
Case tipping may occur if cases are not properly
leveled and secured.
Advertisement
Table of Contents
