Steam Ironing; Burst Of Steam; Dry Ironing - Singer STI-1810 Instruction Manual

Temperature control setting
Acetat
Elastane
Polyamide
Polypropylene
HOW TO FILL WATER
1. Disconnect the iron from the mains supply.
2. Set the steam control to the minimum position.
3. Open the water inlet cover.
4. Fill water through the water inlet hole.
5. Fill up to the 'MAX' level marked on the side of the water tank.
Note: Do not use chemically descaled water or any other liquids.
SPRAYING
Press the spray button, water will be sprayed out from the spray nozzle. Using
this function, you should make sure that there is enough water in the water
tank.

STEAM IRONING

1. To iron with steam, turn the steam control dial to the minimum position and
set the temperature control knob at the "•", "••" or "•••" position.
2. After the pilot light goes out, turn the steam control dial to the suitable posi-
tion. Steam will be produce and ironing can start.

BURST OF STEAM

Set the temperature control knob at the "•••" position & press the burst of steam
button, to remove stubborn wrinkles.

DRY IRONING

Polyester Cotton
Silk Linen
Triacetate
Viscose
Wool
6
ENGLISH