Extron electronics CVEQ1 AAP User Manual page 7

Installation, Setup, Operation, cont'd
1. Cut out the center
corresponds to the type of wall box you are using.
2. Place the template (or the wall box) against the installation
surface, and mark
wall or furnitur e.
3. Cut out the material fr
4. Check the opening
opening. The box and the line driver
connectors should fit easily into the opening. Enlarge or
smooth the edges of the opening if needed.
5. Feed cables thr ough the wall box punch-out holes, and
secur e them with cable clamps to pr
6. Exposed cable shields (braids or foil) are potential sources
of short circuits. Trim back and/or insulate shields with
heat shrink.
CVEQ1, CVEQ1 WM, CVEQ1 AAP • Installation, Setup, Operation
portion of the cut-out template
the guidelines for the opening
om the marked ar ea.
size by inserting the wall
cuit boar 's cir ds and
ovide strain r elief.
Metal Wall Box
Screw
that
on the
box into the
CVEQ1, CVEQ1 WM, CVEQ1 AAP • Installation, Setup, Operation
I
S