Getting Started; Select The Display Language, Acknowledge The Crossover Type And Cancel The Demonstration - Kenwood KDC-BT660U Instruction Manual

Basics
Remote control (RC-406)
(supplied for
Remote sensor (Do not expose to
bright sunlight.)
Pull out the insulation sheet
when using for the first time.
: Can be remotely controlled with an optionally purchased
remote control.
How to replace the battery
To On the remote control
Adjust the volume Press VOL
• Press and hold VOL
the volume to 15.
Press ATT during playback to attenuate the
sound.
• Press again to cancel.
Select a source Press SRC repeatedly.
Turn off the power Press and hold SRC to turn off the power.
( Pressing SRC does not turn on the power. )
/ )
or VOL .
to continuously increase

Getting Started

1
Select the display language, acknowledge the crossover
type and cancel the demonstration
(For /
When you turn on the power for the first time (or [FACTORY RESET] is set to
[YES], see page 7), the display shows: "SEL LANGUAGE"
"VOLUME KNOB"
1 Turn the volume knob to select [ENG] (English) or [TUR] (Turkish), then
press the knob.
[ENG] is selected for the initial setup.
Then, the display shows: "2-WAY X ' OVER" or "3-WAY X ' OVER"
"VOLUME KNOB" "TO CONFIRM".
2
Press the volume knob to acknowledge the current crossover type.
• To change the crossover type, see "Change the crossover type" on
page 7.
Then, the display shows: "CANCEL DEMO"
KNOB".
3
Press the volume knob again.
[YES] is selected for the initial setup.
4 Press the volume knob again.
"DEMO OFF" appears.
)
"PRESS"
"PRESS" "VOLUME
ENGLISH
"PRESS"
5