Getting Started; Select The Display Language, Acknowledge The Crossover Type And Cancel The Demonstration - Kenwood KMM-BT408 Instruction Manual

Basics
Remote control (RC-406)
This unit can be remotely controlled with an optionally purchased remote
control.
Remote sensor (Do not expose to
bright sunlight.)
Pull out the insulation sheet
when using for the first time.
How to replace the battery
To On the remote control
Adjust the volume Press VOL
• Press and hold VOL
the volume to 15.
Press ATT during playback to attenuate the
sound.
• Press again to cancel.
Select a source Press SRC repeatedly.
Turn off the power Press and hold SRC to turn off the power.
( Pressing SRC does not turn on the power. )
or VOL .
to continuously increase

Getting Started

1
Select the display language, acknowledge the crossover
type and cancel the demonstration
When you turn on the power for the first time (or [FACTORY RESET] is set to
[YES], see page 7), the display shows: "SEL LANGUAGE"
"VOLUME KNOB"
1
Turn the volume knob to select [ENG] (English) or [TUR] (Turkish), then
press the knob.
[ENG] is selected for the initial setup.
Then, the display shows: "2-WAY X ' OVER" or "3-WAY X ' OVER"
"VOLUME KNOB" "TO CONFIRM".
2
Press the volume knob to acknowledge the current crossover type.
• To change the crossover type, see "Change the crossover type" on
page 7.
Then, the display shows: "CANCEL DEMO"
KNOB".
3
Press the volume knob again.
[YES] is selected for the initial setup.
4 Press the volume knob again.
"DEMO OFF" appears.
"PRESS"
"PRESS"
"PRESS" "VOLUME
5
ENGLISH