Display Settings - Kenwood KDC-BT660U Instruction Manual

Audio Settings
– : [SUBWOOFER] is selectable only when [SWITCH PREOUT] is set
to [SUB-W] (page 6) and [SUBWOOFER SET] is set to [ON]. (Page 22)
When 3-way crossover is selected:
[TWEETER LEFT]/[TWEETER RIGHT]/[MID LEFT]/[MID RIGHT]/[WOOFER]
– You can only select [WOOFER] if a setting other than [NONE] is selected for
[WOOFER] of [SPEAKER SIZE]. (Page 23)
• [R-SP LOCATION] of [CAR SETTINGS] is selectable only if:
– 2-way crossover is selected. (Page 7)
– A setting other than [NONE] is selected for [REAR] of [SPEAKER SIZE].
(Page 23)
Determining the delay time automatically
If you specify the distance from the currently set
listening position to every speaker, the delay time will
be automatically calculated.
1 Set [POSITION] and determine the listening
position as the reference point (the reference point
for [FRONT ALL] will be the center between the
right and left in the front seats).
2 Measure the distances from the reference point to
the speakers.
3 Calculate the distance between the furthest speaker
(subwoofer on the illustration) and other speakers.
4 Sets the [DISTANCE] calculated in step 3 for
individual speakers.
5 Adjusts [GAIN] for individual speakers.
Example: When [FRONT ALL] is selected as the
listening position.

Display Settings

Zone identification for color settings and brightness settings
Zone identification for brightness settings
Set the dimmer
Press and hold DISP to turn on or off the dimmer.
• Once you press and hold this button, [DIMMER] setting (page 26) will be
overwritten.
Select the illumination color
You can change the illumination color (preset colors, see page 26) of the
last selected zone. By default, [ALL ZONE] is selected.
Press COL repeatedly.
• Pressing and holding COL enters [COLOR SELECT] directly.
(for )
ENGLISH
25