Upper Case Removal - Epson STYLUS PRO XL 4004677 Service Manual

Stylus Pro XL

3.2.1 Upper Case Removal

1. 1. Remove the printer cover (center of top) by releasing the 2 tabs holding it to the upper case.
2. Remove the front cover (front of top) by releasing the 2 tabs holding it to the lower case.
3. Remove the paper guide by releasing the 2 tabs holding it to the printer mechanism.
4. Move the carriage to the middle of the printer while pressing the hook that fixes the carriage
unit to the home position.
5. Remove the control panel. (Release the tab by inserting a screwdriver into the hole in the upper
case, as shown in the figure below.) At this time, disconnect the connector on the C137 PNL
Board.
Figure 3-2. C137 PNL Control Panel Removal
5.
Remove the 2 CBB (M3 11) screws securing the upper case to the lower case.
6. Release 1 tab by inserting a flathead screwdriver into the holes at the bottom of the lower case,
as shown in the figure below.
7. Remove the upper case by lifting the front side. At the same time release 1 tab, located in the
center front of the lower case.
DISASSEMBLY/ASSEMBLY POINT
Hold the upper case firmly and pull it to remove it, while you release the tabs.
REV.-A
Figure 3-3. Upper Case Removal
Disassembly and Assmbly
C137 PNL Board
Cable
Carriage Lock Lever
CBB (M3x11)
3-3