Table of Contents
Advertisement
Adjustments
4.1.1 Destination Data Writing Operation
The setup value that specifies the printer destination is stored in the EEPROM on the C162 MAIN
board. Therefore, this setup value must be written into the EEPROM when the MAIN board or
EEPROM chip is replaced.
Before writing the destination data writing, set the interface to parallel.
1.
Connect the PC to the target printer using a parallel interface cable and turn the printer on.
2.
Execute BASIC on the PC, and run the program "VERxxx.BAS." You see the following menu.
1. Destination Setting
2. Head Angle Confirmation Pattern Printing
3. Head Vertical Position Confirmation
4. Head Gap Adjustment
5. Bi-D Adjustment
6. Internal Timer Reset
7. END
3.
When the main menu appears, choose "Destination Setting" by typing 1 and Enter.
4.
The main menu immediately disappears briefly and then reappears. (At this time, specific
destination parameters, including the destination, interface mode, TOF value, and
economy/condensed, are automatically written to the EEPROM.)
5.
Choose "END" by typing 7 and ENTER. The next message appears on the display.
All parameters that you have specified so far
are written to EEPROM upon power off.
6.
Turn off the printer.
4-2
CAUTION
(Black Head Spacer Selection)
Turn the printer OFF, Now!
Stylus Pro XL
Rev. A
Advertisement
Chapters
Table of Contents
Troubleshooting
