Figure 4-6. Removing The Rubber Cap - Epson STYLUS PRO XL 4004677 Service Manual

Stylus Pro XL
7. Turn the printer power off now.
8. Manually move the carriage to the center while pressing the carriage lock lever, and remove
the two ink cartridges.
9. Remove the rubber cap covering the head screw at the side of color ink cartridge. Then loosen
(but do not remove) 3 screws. (Refer to Figure 4-6.)
Carriage Unit
After replacing the spacer, always install new ink cartridges before returning the printer to
the user. During this adjustment, use ink cartridges exclusively for service (Monochrome:
1020626, CMY: 1020627). You can reuse old ink cartridges for other purposes.
10. Replace the angular spacer for the black head with a new one, referring Figure 4-7.
(Replace the angular spacer by using tweezers to push the head base toward the rear.)
Rev. A
Platen Gap
Adjust Lever

Figure 4-6. Removing the Rubber Cap

WARNING
Black Head
1: Push
Head Base
Angular Spacer
Linear Spacer
(Angular Spacer
Replacement Position)
Adjustments
2: Replace
4-7