Table of Contents
Advertisement
Safety instructions for the
installation technician
• In the electrical installation a device must be
provided which allows the appliance to be
disconnected from the mains at all poles with a
contact opening width of at least 3 mm.
Suitable isolation devices include protecting
cut-outs, fuses (screw type fuses are to be
removed from the holder), earth leakage trips
and contactors.
• With regard to fire protection this appliance
complies with EN 60 335-2-6. Only this type of
appliance may be installed with a high
cupboard or wall on one side.
• The required minimum distances to other
appliances
(refer
specification)
of
maintained.
• Drawers shall not be fitted underneath the hob.
• The installation must ensure protection against
shock.
• The kitchen unit in which the appliance is fitted
must satisfy the stability requirements of DIN
68930.
• For protection against moisture, all cut
surfaces must be sealed with a suitable sealing
material.
• On tiled work surfaces, the joints in the area
where the hob sits must be completely filled
with grout.
• On natural, artificial stone or ceramic tops, the
snap action springs must be bonded in place
with a suitable artificial resin or two-component
adhesive.
• Attach the four supplied one-sided adhesive
liner tapes to the lower side of the hob along
the outer rim of the glass ceramic pane. Do not
expand. The ends of the liner tapes must
overlap.
• For dismantling, the hob must be pressed out
from below.
• Clean the worktop around the cutout area.
to
their
technical
your
kitchen
must
be
34
Hide quick links:
Advertisement
Table of Contents
