Dremel 231 Operating/Safety Instructions Manual page 5

Mount Table to Workbench
The SHAPER/ROUTER TABLE comes
assembled ready to mount to the workbench.
After determining table location, predrill the
bench using a 1/8" diameter drill at the four
mounting hole locations. Secure table to the
bench using the (4) #10 x 1" wood screws,
and washers. (Included with the Shaper/
Router Table). (See Fig. 1)
Alternative mounting option: To make your
shaper table more portable, mount to piece
of 2" x 4". Then easily clamp to your work
bench as shown in Fig. 1.
Install Rotary Tool to Table
1. Loosen the clamp knob and turn depth
adjustment knob to lower tool holder.
2. With the Rotary Tool unplugged from a
power source, remove the threaded
housing cap off of tool and set housing cap
aside. The housing cap must be reinstalled
when not using Shaper/Router table.
3. Place tool into attachment with shaft lock
button and on/off button facing forward.
4. Thread locking nut clockwise onto the
threaded portion of your Rotary Tool and
securely tighten
wrench (See Fig. 2).
Read and understand these
WARNING
!
instructions and the tool
manual before using this accessory.
with the provided
Fig. 1
(4) #10 x 1"Wood
Screws &
Fig. 2
Clamp
Knob
Depth
Adjustment
Screw
5
Washers
Use 2' x 4" as
alternative
mounting option
Guard
On/off switch
must face
forward so
that turning off
tool is readily
accessible
Fence