Making Connections - Raymarine REALVISION 3D Installation Instructions Manual

The locking collar slides easily towards the plug-end of the connector, before butting up against
the split-ring moulding.
7. Grasp the body of the connector with one hand, then with the other hand, pull the locking collar
firmly towards the plug-end of the connector.
As you pull the locking collar, it clicks into place over the split-ring. The locking collar stays in
position on the connector, but rotates freely.

4.4 Making connections

Follow the steps below to connect the transducer cable to a RealVision™ 3D sonar-capable device
(for example, Axiom RV multifunction display).
1. Ensure that the vessel's power supply is switched off.
2. If your installation comprises split-pair transducers:
34