Raymarine REALVISION 3D Installation Instructions Manual page 21

• A = 60.00 mm (2.36 in)
• B = 42.00 mm (1.65 in)
• C = 35.00 mm (1.40 in)
• D = 76.00 mm (2.99 in)
• E = 87.00 mm (3.43 in)
• F = 8.00 mm (0.31 in)
• G = 145.00 mm (5.71 in)
• H = 35.00 mm (1.4 in)
• I = 85.00 mm (3.35 in)
• J = 68.00 mm (2.68 in)
• K = 14.90 mm (0.59 in)
• L = 347.51 mm (13.68 in)
• M = 114.00 mm (4.49 in)
Nut sizes
• Hull nut — 68 mm (2 ¾ in) across flats
• Anti-rotation nut — 13 mm (½ in) across flats
RealVision transducer cable connector dimensions
The dimensions of the transducer cable the cable connector are shown below.
Cable connector dimensions
• A = 32.00 mm (1.26 in)
• B = 25.00 mm (1.00 in)
• C = 96.00 mm (3.80 in)
• D = Cable length
– Single (All-in-one) transducer attached cable length: 8 m (26.2 ft).
– Split pair transducer attached cable length: 2 m (6.5 ft).
• E = 138.6 mm (5.46 in). This dimension is dependent on your MFD variant. Refer to your MFD
documentation (Model shown is Axiom Pro 16).
• F = 68.4 mm (2.69 in) Maximum. This dimension is dependent on your MFD variant. Refer to your
MFD documentation (Model shown is Axiom Pro 16).
• G = 35.00 mm (1.40 in)
Note:
For installations where space behind the display is limited, a right-angled transducer cable adaptor
is available (A80515). Using the right angled cable adaptor will reduce dimension P above by
20 mm (0.79 in.)
Installation 21