Table of Contents
Advertisement
You can now remove the tool. The split-ring stays in position on the connector, but rotates freely.
5. Slide the O-ring (arrowed) over the end of the connector, and ensure that it is seated squarely
against the connector moulding, adjacent to the split-ring.
6. Slide the locking collar towards the plug-end of the connector, rotating the collar as necessary
to ensure that the lugs on the locking collar (labelled 'D' in the illustration) pass through the
channels (labelled 'E') in the split-ring.
Connections
33
Advertisement
Table of Contents
Troubleshooting
