FujiFilm FinePix F30 Service Manual page 93

FinePix F30 Service Manual
Sequemnce Item
13 Current Auto mode
consumption
check
14 Battery Charge Power off
15 Factory setting
Mode Preparations for adjustment
(measurement points, subject, other)
(1) Connect the power supply
jig to the battery terminal.
(2) Set the power supply
voltage.
(3) Attach the dummy battery
cover.
(4) Set the Mode dial to AUTO
mode and turn the camera
on.
(5) After the LCD live image
appears, check the current
consumption.
(6) Check that the flash is set
to red-eye reduction mode.
(1) Insert NP-95 battery to the
camera.
(2) Close the battery cover.
(3) Connect the AC-5V to the
camera.
(4) Charge function
confirmation.
(1) Mode dial.
(2) SETUP frame no.
(3) Battery and cards not
inserted.
(4) Internal memory.
(5) Battery cover.
(6) Check that the lensretracts
and that the lensbarrier
areclosed.
(7) Power off.
5. Inspection
Method of adjustment
(VRs, waveforms, required values)
(2) 3.70 V ± 0.05 V
(5) 550 mA or less
(6) Backup check.
(4) Charge LED lights on.
(1) AUTO mode
(2) New: The default SETUP
frame No. setting is
"Continuous", but to clear
the number of frames in
the frame number memory
to zero, you should always
change the setting to
"New" before turning the
camera off.
(3) Normal
(4) Check that the internal
memory is formatted.
* Excluding customers
camera.
(5) Closed
(7)The power supply is
stopped after the camera's
shutdown sequence ends.
*Setting and clearing date
(1) Connect the USB
cablefrom the PC to the
camera (ensure that the
PC isswitched ON).
(2) Open the card cover
andswitch power ON
(POWER_ON) while
pressing the shutter
button.
(3) Switch power OFF
(POWER_OFF).
(4) Check that the date
hasbeen cleared.
Measuring Measurement points
equipment and jigs (VRs, positions)
ZJ00979-100
93