FujiFilm FinePix F30 Service Manual page 53

FinePix F30 Service Manual
<Step 3>
Select the "EVR & Comm." tab ([1] in Fig. 4-6-3) in the
"Customize" dialog box that appears.
Set the "EVR" items ([2] in Fig. 8) as follows.
Item
etc (-V2) Check
LANC page Check
<Step 4>
Select the "Etc" tab ([1] in Fig. 4-6-4) in the "Customize"
dialog box that appears.
Set the "Etc" items ([2] in Fig. 4-6-4) as follows.
Item
# of auto measure 0
Change mode Do not check
Use Japanese font Do not check
Don't show OK NG Check or Do not check
[Note]
If [Disable OKNG display] on the PC screen (Fig. 4-6-4) is
set to OFF, the PC screen displays [OK] if adjustment is
OK,and [NG] if adjustment is NG (either setting is OK).
<Step 5>
Select the "Hardware" tab ([1] in Fig. 4-6-5) in the
"Customize" dialog box that appears.
Input the values for PI and P Board ([2] in Fig. 4-6-5).
PIO 0 10
PIO 1 11
Set the "Hardware" items ([3] in Fig. 4-6-5) as follows.
Item
Debug Mode Select [Default]
<Step 6>
Once the above settings have been made, click on "Apply"
([4] in Fig. 4-6-5) in the "Customize" dialog box to complete
setup.
This applies the setup, therefore setting is unnecessary from
the next time forward.
Details
Details
12 14 16
13 15 17
Details
4. Adjustments
(2) (1)
<Fig. 4-6-3>
(2)
<Fig. 4-6-4>
(1)
<Fig. 4-6-5>
(2)
(3) (4)
53