FujiFilm FinePix F30 Service Manual page 91

FinePix F30 Service Manual
Sequemnce Item
6 Movie/audio Movie
recording check mode
7 Movie/audio Playback
playback check
8 Playback check Playback
Mode Preparations for adjustment
(measurement points, subject, other)
(1) Select the mode dial to
Movie shooting mode.
(2) Press S1 -> S2 and then
release S2 -> S1.
(3) After 5 seconds, press and
then release S1.
(1) Set the camera to
Playback mode.
(2) Press the 4-way button
(down) to play back the
movie.
(1) Plug the AV cable into the
camera.
(2) Check images shot using
the flash (18% gray chart,
shot at a distance of 1 m).
(3) Check images shot at
macro resolutions (manual
photography).
(4) Disconnect the AV cable
from the camera.
Turn the camera off.
1%
Vectorscope center
10% circle
Check that the Y level is 46 to 10 IRE (NTSC) or 322 to 70 mV (PAL).
5. Inspection
Method of adjustment
(VRs, waveforms, required values)
(1) Check that "STANDBY"
appears on the LCD
monitor.
(2) Check that movie/audio
recording begins.Check
that "REC" appears on the
LCD monitor.
(3) Check that movie/audio
recording ends and that
the data is recorded on the
card.
(2) Check that the movie is
played back on the LCD
monitor.
Check that the sound is
played back through the
speaker.
(1) The LCD image
disappears and the
indicator lamp lights green.
(2) Check that the position
ofthe bright spot is within
a10% circle with a
centerthat is X = 1% and Y
= -3%from the center of
thevectorscope (see figure
below).
(3) Where the horizontal
resolution is as follows:
350 TV lines or better at
the center and 300 TV
lines or better at the
periphery (NTSC).
300 TV lines or better at
the center and 250 TV
lines or better at the
periphery (PAL).
Check that the bright point
center is within specifications.
3%
Fig
Measuring Measurement points
equipment and jigs (VRs, positions)
Vectorscope
TV monitor
91
.