Connecting To An Automation System - Pentair STA-RITE INTELLIFLO3 VSF Installation And Maintenance Manual

4

Connecting to an Automation System

All IntelliFlo3 VSF and IntelliPro3 VSF pumps are compatible with Pentair automation systems. Refer to the
automation system manual for further details on connecting your pump to a specific automation system.
Use 18 to 24 AWG, two-conductor cable to connect a Pentair automation system to the pump.
WHEN THE PUMP IS CONNECTED TO AUTOMATION:
• CONNECT LED will pulse Magenta/Pink
• Touchscreen Controller (if installed) will display a message indicating the pump is being controlled by an
automation system
• Pentair Home app will display a message confirming the pump is being controlled by an automation system
• All pump control is handled by the automation system
• When putting the automation mode into Service Mode, the automation system will return control to the pump
An IntelliTouch Automation System with firmware 1.170 or earlier will display "VSF+SVRS" in the pump type/
selection. While you will choose this option, the pump does NOT incorporate SVRS entrapment protection.
If operating the pump with a Pentair automation system, when the pump is disconnected from automation
or in service mode it will continue operating according to the factory default programs/schedules. Ensure
programs/schedules are edited or disabled before servicing the pump.
RS-485 WIRING
+12V
DATA+
DATA –
GND
RS-485
(Low Voltage)
*Note: Digital Input and Pump Relay connections are only available if the optional
Relay Control Board (P/N 356365z) is installed.
Refer to Relay Control Board Digital Inputs, page 5 for more information.
INTELLIFLO3™ VSF / INTELLIPRO3™ VSF Variable Speed and Flow Pump Installation and Maintenance Guide
RED
YELLOW
GREEN
BLACK
DIGITAL INPUTS*
(Low Voltage)
DIGITAL INPUT WIRING
VOUT OUTPUT FOR D.I. TRIGGER (+12V)
GND GROUND
SP1 SPEED 1 DIGITAL INPUT (5-24V AC/DC)
SP2 SPEED 2 DIGITAL INPUT (5-24V AC/DC)
SP3 SPEED 3 DIGITAL INPUT (5-24V AC/DC)
SP4 SPEED 4 DIGITAL INPUT (5-24V AC/DC)
5A MAX
DEVICE / L2
SUPPLY / L1
SUPPLY / L2
DEVICE / L1
16A MAX
DEVICE / L2
SUPPLY / L1
SUPPLY / L2
DEVICE / L1
PUMP RELAYS*
Common Devices Wired to Relays
Salt Chlorine Generator
5A
(Left-side)
Pool Light / Transformer
Booster Pump
16A
Single Speed Pump
(Right-side)
Spa Blower