Troubleshooting; Drive Led Indicators; Troubleshooting Chart - Pentair STA-RITE INTELLIFLO3 VSF Installation And Maintenance Manual

Always disconnect power to the pump at the circuit breaker and relieve pressure in the filtration system before servicing the pump. Failure
to do so could result in death or serious injury to serviceman, pool users or others due to electric shock. Do NOT attempt to adjust or
service without consulting your dealer or a qualified pool technician. Read the entire Installation and Maintenance Guide before attempting
to use, service, or adjust the pool filtering system or heater.

Drive LED Indicators

Each button on the drive;
CONNECT, ON/STOP and
QUICK CLEAN features an
LED indicator.
Refer to the table to the right
for a list of LED behaviors
and what they are indicating.
= Solid LED
= Blinking LED
= Pulsing LED

Troubleshooting Chart

PROBLEM
Connection Issue -
Pump is Offline Alert
LED
Green
Blue
CONNECT
Yellow
Magenta/Pink
Green
ON/STOP
Red
Green/Yellow
Yellow
POSSIBLE CAUSE
Pump is not receiving power
Home internet service is out or
inaccessible
Intermittent WiFi or network
connection
connectivity issues
Bluetooth
®
- Troubleshooting Continues on the Next Page -
INTELLIFLO3™ VSF / INTELLIPRO3™ VSF Variable Speed and Flow Pump Installation and Maintenance Guide

TROUBLESHOOTING

BEHAVIOR
Pulsing Attempting to establish WiFi connection
Solid Active WiFi connection
Blinking Attempting to establish a Bluetooth
Solid Active Bluetooth
Pulsing Pump requires provisioning
Blinking Pump update in progress
Solid Automated control is active
Pulsing Connected to automation and in service mode
Solid Pump running
Blinking Priming cycle
Pulsing Pump in Thermal Mode
Solid Pump disabled
Blinking Alarm detected
Blinking Warning detected
Solid Pump is idle
CORRECTIVE ACTION
Ensure the pump is receiving power.
If the pump is receiving power, the ON/STOP button will
illuminate.
Confirm that the home router is active and connected to
the internet.
1. Restart the home router. This can clear up many
typical home networking issues.
2. Cycle power to the pump.
Disconnect power to the pump at the main breaker,
Wait for 1 minute and reconnect power.
3. Check the signal strength in WiFi Settings of the
Pentair Home App.
If the signal strength is insufficient, refer to the Poor
WiFi Signal section of this troubleshooting chart.
1. Stand closer to the pump when operating via
Bluetooth .
®
2. Restart the Pentair Home app.
3. Adjust the pump antenna.
4. Ensure smartphone permissions are given to the
pump.
INDICATES
connection
®
connection
®
19