Emotiva BasX PT1 User Manual page 30

Connecting speakers to your BasX TA1
To connect your TA1 to a pair of speakers simply connect the speakers to the Left and Right
Speaker Outputs on the TA1. Set the Crossover Switch on the TA1 to Full Range.
TA1
Connecting speakers and a subwoofer to your BasX TA1
To connect your TA1 to a pair of speakers and a subwoofer, connect the speakers to the Left and
Right Speaker Outputs on the TA1, and connect the LP Xover-Out to the input on your powered
subwoofer. Set the Crossover Switch on the TA1 to High Pass. If your subwoofer has an LFE input
then use that; if not, then use a normal input, and set the crossover frequency on your subwoofer
to its highest setting to use the active bass management crossover in the TA1.
TA1
POWERED
SUBWOOFER
Note: The active bass management high-pass filter is always applied to the HP Xover-Out
outputs on the TA1. The setting of the Crossover Switch controls whether the active high-pass
filter is applied to BOTH THE MAIN OUTPUTS AND THE SPEAKER OUTPUTS.
BasX PT1 and BasX TA1
BasX TA1 with Two Speakers
ANALOG OUTUTS
MAIN
X-OVER OUT
OUT
L
Set Switch to
MONO HIGH PASS
|
FULL RANGE
R
|
FULL RANGE
LP (90Hz) HP
BasX TA1 with Two Speakers + Subwoofer
ANALOG OUTUTS
MAIN
X-OVER OUT
OUT
L
Set Switch to
HIGH PASS
MONO
|
HIGH PASS
R
|
LP (90Hz) HP FULL RANGE
SPEAKER OUTPUTS
R
SPEAKER OUTPUTS
R
Page 26
L
L