Emotiva BasX PT1 User Manual page 26

BasX PT1 and BasX TA1
Dim - Allows you to configure the brightness of the front panel VFD display.
(Options include 0%, 20%, 40%, 60%, 80%, and 100%.)
Reset - Resets all configuration settings and Tuner Presets to their factory default settings.
(After selecting this option you will be prompted to confirm your choice.)
Version - Displays the current firmware version.
Region - Configures the FM tuner for use in the USA or European region.
(Pre-emphasis and de-emphasis are applied to the FM audio signal to reduce noise. There are two
standards, and you will get the most accurate sound reproduction if you pick the correct one for
your area. For the USA and Canada, select USA; the Europe setting is correct for most other areas...
or just select the one that sounds the best to you.)
Autotune - When you select this option the FM Tuner in your unit will scan through the FM
frequency band and preload as many strong stations as it can detect into the FM tuner's 15
station presets. After pressing the Right button to start the Autotune process, it will proceed and
complete automatically.
Note: Using Autotune will ERASE your current FM Station Presets and replace them with the
stations found by the signal scan.
The Tuner Section
The Tuner Section of the Menu System gives you access to the functions necessary to program
and configure the FM Tuner Presets. (The entire Tuner Section will ONLY be visible if the Tuner
Input was selected when you entered the Menu System.)
Preset - Allows you to choose which Tuner Preset station to listen to.
Press the Right button to see the currently selected Preset; use the Volume knob or Up / Down
arrow buttons to change to a different Preset; use the Left Button to exit when you're done.
Save - Allows you to save the currently selected frequency to a Tuner Preset.
Press the Right button to select Save; the current Frequency and Preset will be shown. Use the
Volume knob or Up / Down buttons to select the Preset you wish to save; the currently selected
combination of Frequency and Preset will be continuously displayed. Press the Right button to
save the displayed Frequency to the displayed Preset.
Mono/St - Instructs the tuner to play a weak FM station in monaural.
Because of the way FM broadcasts are encoded, stereo FM broadcasts often exhibit an
unacceptably high amount of background noise if the signal is too weak. If this occurs, switching
the decoder to monaural mode will often improve the signal quality significantly. This may enable
you to receive more stations in "listenable quality".
Press the Right button to enter the Menu item, use the Up / Down buttons or Volume knob to
select Mono or Stereo; use the Left Button to exit when you're done.
Note: The Mono/St setting ONLY affects stereo FM broadcasts. It has no effect on monaural FM
boradcasts and does NOT convert other types of stereo audio inputs to monaural.
Page 22