Tilt Rod Assembly - BRP EVINRUDE E-TEC 200 Service Manual

TRIM AND TILT
TRIM AND TILT SERVICE
Use a screwdriver t o carefully pry the scraper out
of the end cap. Discard the scraper. Remove and
discard the large outer O-ring.
Remove and discard inner O-ring of the end cap.

Tilt Rod Assembly

Clean the end cap thoro ughly, then lubricate and
install a new O-ring in the en d cap. Lubricate and
install a new scraper. The scraper is installed with
the lip fa cing out. Lu bricate and inst all a new
O-ring on the outside of the end cap.
1
1. Inner O-ring
2. Lip
3. Outer O-ring
354
Use a wire brush to clean all thread-locking mate-
rial from the threads on the tilt rod.
41791
Lubricate the inside surface of the end cap. Lubri-
cate an d in stall T ilt Cylinder
P/N 326005. Use a deep-well socket and a plastic
mallet to drive the end
remove the seal protector. Slide the end cap down
the tilt rod.
41792
1
1. Tilt Cylinder Seal Protector P/N 326005
Remove any lubricant from the threads on the tilt
2
rod, prime with Locquic Primer, and let d ry. Slide
the piston assembly onto the tilt rod. Place a new
rod O-ring over the threads.
3
1
41795
1. O-ring
41821
Seal Protector,
cap ont o the rod, th en
41824
41816