Installing The Main Unit - Clarion NX501 Owner's Manual & Installation Manual

5. Installing the Main Unit

This unit is designed for fixed installation in the
dashboard.
1. When installing the main unit in NISSAN vehicles,
use the parts attached to the unit and follow the
instructions in Figure 6.
When installing the main unit in TOYOTA vehicles,
Mounting Screw Holes (Side View of the Main Unit)
For NISSAN vehicle
Installing the Main Unit in NISSAN Vehicle
Trim ring
Note:
* 1: Position the face panel with its wide edge at the bottom. Fit the edge
into the groove of the main unit.
Figure 5
Main Unit
Mounting bracket
(1 pair for the left and right sides)
Figure 6
use the parts attached to the vehicle and follow the
instructions in Figure 7.
2. Wire as shown in Section 7.
3. Reassemble and secure the unit in the dashboard
and set the face panel and center panel.
For TOYOTA vehicle
6- Spacer (thickness: 1mm)
6-Spacer (thickness: 1 mm)
6- Flat head screws
6-Flat head screw
(M5 8)
(M5x8)
(attached to the main unit)
(Attached to the main unit)
61
NX501/NZ501