Lincoln Electric VRTEX ENGAGE Operator's Manual page 55

VRTEX ® ENGAGE™
Observe Safety Guidelines
detailed in the beginning of this manual.
PROBLEMS
(SYMPTOMS)
The machine was shut down and will not
turn back on when the green circular button
is pressed.
The user cannot weld a second pass.
The VRTEX Engage does not start up when
the when the green circular button is
pressed.
If for any reason you do not understand the test procedures or are unable to perform the test/repairs safely,
contact the Lincoln Electric Automation Department for electrical troubleshooting assistance before you proceed. Call 1-888-935-3878.
POSSIBLE AREAS OF
MISADJUSTMENT(S)
1. The system may still be in shut down
mode.
1. The joint configuration may be set up for
one pass only.
1. Make sure the correct input power is
being applied to the machine.
2. Verify fused power switch is in the ON
position.
3. Fuse may be faulty.
CAUTION
TROUBLESHOOTING
TROUBLESHOOTING GUIDE
RECOMMENDED
COURSE OF ACTION
1. Wait 20 seconds, then press and hold
the green circular button for 5 seconds
to start the machine.
1. Check the tolerance editor to verify the
joint configuration allows for multiple
pass welding.
1. Be sure to hold the green circular button
in for at least 5 seconds.
2. Replace with 10A/250V fuse only.