Lincoln Electric VRTEX ENGAGE Operator's Manual page 37

VRTEX ® ENGAGE™
7. Set the polarity, wire feed speed and voltage. Select the continue
icon. See Figure B.59. See the WPS Book for the correct settings.
Figure B.59 – Polarity, wire feed speed and voltage
8. Once all settings have been entered, select the check settings icon
to verify that the entered settings are correct for the weld process
chosen. See Figure B.60. If settings are correct you will be taken
to the weld environment. If the settings are incorrect, there will
be a message displayed on the screen and it will be necessary to
adjust the settings accordingly. See Figure B.61.
Figure B.60 – Check settings
Figure B.61 – Incorrect settings
9. When the environment screen appears tap the screen to skip to
welding. See Figure B.62.
Figure B.62 – Environment screen
10. Using the GMAW gun and the weld area, begin welding. See
Figure B.63. To begin weld over select the New Coupon icon
and practice the weld again. See Figure B.64. When weld is
complete select the End Pass icon and select the Next icon (white
arrow) to enter the LASER (Live Action Student Evaluation Report)
Screen. See Figure B.65.
Figure B.63 – GMAW gun device and weld area
WELD
AREA
Figure B.64 – Welding screen
B-21
OPERATION (USER MODE)
GMAW GUN
DEVICE