Lincoln Electric VRTEX ENGAGE Operator's Manual page 40

VRTEX ® ENGAGE™
7. Using the on-screen keyboard, enter the password again to
confirm and select the Continue icon. The password must match
the previously entered password. See Figure B.73.
Figure B.73 – Confirm password
8. Review the profile information to the left of the screen. If the
profile is correct select the Continue icon to verify the profile. See
Figure B.74. If the profile information does not look correct, select
the Back icon and correct the profile information. Once verified a
new profile will be created and added into this VRTEX Engage unit.
The user should record and save the login information in a secure
location. After verifying profile, login with your new profile and
begin working.
NOTE: Only instructors can edit profile information.
Figure B.74 – Verify password
9. Using the on-screen keyboard, enter the username and select the
Continue icon. See Figure B.75.
Figure B.75 – Login username
10. Using the on-screen keyboard, enter the password and select the
Continue icon. See Figure B.76.
Figure B.76 – Login password
11. Using the touch screen monitor, select the appropriate training
group by tapping either the red arrow(s) or the small box (with
the group name in it) above or below the center box. See Figure
B.77. The training group will be displayed in the center box.
Select continue when the desired training group is shown in the
center box.
NOTE: This guide will take the user step-by-step through the
'Introduction GMAW 2F' training group. See Table B.1. The
basic processes used to progress thru this training group will
apply to all training groups. Lesson names will be noted in
brackets (Lesson Name).
Figure B.77 – Select group
B-24
OPERATION (USER MODE)