Robertshaw RS9110 Installation Manual page 16

TECHNICIAN SETUP MENU
Tech Settings
This feature will flash FILT in the
display after the elapsed run time
Filter Change
to remind the user to change the
filter. A setting of OFF will disable
Reminder
this feature.
This feature allows the installer
to change the calibration of the
Room
room temperature display. For
Temperature
example, if the thermostat reads
Calibration
70° and you would like it to read
72° then select +2.
This feature allows the installer
to select the minimum run
time for the compressor. For
Minimum
example: A setting of 4 will force
Compressor
the compressor to run for at
On Time
least 4 minutes every time the
compressor turns on, regardless of
the room temperature.
14
LCD Will Show Adjustment Options
You can adjust the filter change
reminder from OFF to 2000
Next step
hours of run time in 50 hour
increments. Tap the second
button from the top left side of
the thermostat to display the
current filter elapsed run time.
Prev step
Next step
You can adjust the room
temperature display to read
3° above or below the factory
calibrated reading.
Prev step
You can select the minimum
compressor run time from OFF,
Next step
3, 4, or 5 minutes. If 3, 4 or 5 is
selected, the compressor will
run for at least the selected
time before turning off.
Prev step
Default
OFF
0
OFF