Table of Contents
Advertisement
Figure 15. Leader pin in the incorrect and correct positions. The cartridge door is open and
the leader pin is visible inside the cartridge.
66
Half-High LTO Gen 5 SAS Tape Drive Installation and User's Guide
To reposition the leader pin, see Figure 16 and complete the following steps:
1. Slide open the cartridge door and locate the leader pin.
Note: If necessary, shake the cartridge gently to roll the pin toward the door.
2. With plastic or blunt-end tweezers, grasp the leader pin and position it in the
pin-retaining spring clips.
3. Press the leader pin gently into the clips until it snaps into place and is firmly seated.
4. Close the cartridge door.
5. Make sure that there are no gaps in the seam of the cartridge
Figure 16. Placing the dislodged leader pin into the correct position
Advertisement
Table of Contents
