Table of Contents
Advertisement
5. After viewing all error codes, exit this function by pressing the Unload button
again. The SCD will display
Function code A: Clear error code log
Function code
To execute Function code A: Clear error code log, complete the following steps:
1. Put the drive in Maintenance mode. For instructions, see "Entering
Maintenance mode" on page 25.
2. Press the Unload button once per second until
cycle past the desired code, press the Unload button once per second until the
code reappears.)
3. Press and hold the Unload button for 3 or more seconds, then release it to
select the function.
erases all errors from the error code log and exits Maintenance mode.
Function code C: Insert cartridge into tape drive
You cannot select this function; it is part of other maintenance functions (such as
Run tape drive diagnostics and Create FMR tape) that require a tape cartridge to
be inserted.
Function code E: Test cartridge & media
Approximate Run Time = 15 minutes per loop
Total Number of Loops = 10
Function code
its magnetic tape are acceptable.
Press the Unload button to stop the diagnostic and exit Maintenance mode. Press
the Unload button once to abort the test at the end of the current test loop. Press
the Unload button twice to abort the test immediately. Wait for the drive to rewind
the tape and unload the cartridge.
Attention: When you perform this test, data on the suspect tape will be
overwritten.
Note: If you inserted an invalid tape cartridge (for example, Gen 2 or WORM
media), error code
write-protected cartridge, or the media has read-only compatibility (for
example, Gen 3 media), error code
the tape drive unloads the cartridge and exits Maintenance mode after the
cartridge is removed.
To execute Function code E: Test cartridge & media, complete the following steps:
0
and exit Maintenance mode.
A
erases the contents of the error code log.
A
flashes in the SCD, followed by
E
performs tests that determine whether a suspect cartridge and
J
7
or
appears in the SCD. If you inserted a
A
appears in the SCD. (If you
0
. The tape drive
P
appears in the SCD. In either case,
Chapter 3. Operating
33
Advertisement
Table of Contents
