Display
Tips & Tricks
For more information
about adjusting the
brightness, see
"System key
combinations" on
page
22.
The diskette may be full. Delete
■
unnecessary files on the diskette and try
again.
Not all diskettes are IBM-compatible. Make
■
sure that the diskette you are using is
IBM-compatible.
Try a different diskette. Occasionally
■
diskettes are flawed and cannot be read by
the diskette drive.
You see a "Disk is full" error message
Delete unnecessary files on the diskette.
■
Try a different diskette. Occasionally
■
diskettes are flawed and cannot be read by
the diskette drive.
Run Error checking on the diskette. If errors
■
are detected and corrected, try using the
diskette again. For instructions on running
Error checking, see "Checking the hard
drive for errors" in the online User Guide.
You see a "Non-system disk" , "NTLDR is
missing" , or "Disk error" error message
Eject the diskette from the diskette drive,
■
then press E
Make sure that the diskette you are using
■
is IBM-compatible.
The modular drive status indicator is lit
continuously
Remove the diskette from the drive. If the
■
indicator stays on, try restarting your
notebook.
The screen is too dark
Adjust the brightness using the system keys.
Troubleshooting
.
NTER
87