Replacing The System Battery - Gateway 3200SE User Manual

Chapter 5: Maintaining Your Computer

Replacing the system battery

If the computer clock does not keep time or the settings in the BIOS Setup utility are
not saved when you turn off your computer, replace the system battery. Use a battery
of the same size and voltage as the original battery that was in your computer.
Warning
To replace the battery:
1
Restart your computer.
2
During the restart, press and hold the F1 key. The main menu of the BIOS Setup utility
opens.
3
Write down all the values in the menus and submenus, then exit from the utility.
4
Shut down your computer.
5
Remove the side panel by following the instructions in
on page 50.
6
For more stability, place your computer on its side. To avoid scratching the case, place
it on a towel or other non-abrasive surface.
7
Locate the old battery on the system board and note its orientation. You will need
to install the new battery the same way.
8
Push the battery release tab. The battery pops out of the socket.
56
Danger of explosion if battery is incorrectly replaced.
Replace only with the same or equivalent type recommended by the
manufacturer. Dispose of used batteries following the manufacturer's
instructions.
www.gateway.com
"Removing the side panel"