Installing The Battery; Mounting Your Zūmo In An Automobile - Garmin Zumo 660 Owner's Manual

Getting Started

Installing the Battery

1. Locate the lithium‑ion battery that came in
the product box.
2. Slide the release key until the battery
cover on the back of the zūmo pops up.
3. Locate the metal contacts on the end of
the lithium‑ion battery.
4. Insert the battery so that the metal
contacts on the battery align with
the metal contacts inside the battery
compartment.
5. Replace the battery cover.
CauTion: Always keep the battery
installed when the zūmo is on.
6
Mounting Your zūmo in an
Automobile
Warning: Do not use the suction cup
mount on a motorcycle.
1. Plug the automotive power cable into the
power connector on the right side of the
cradle.
Release button
Cradle
Automotive
power cable
2. Remove the clear plastic from the suction
cup. Clean and dry your windshield and
the suction cup with a lint‑free cloth.
Suction cup mount
3. Place the suction cup on the windshield.
4. Flip the lever back, toward the windshield.
5. Snap the cradle onto the suction cup arm.
6. Fit the bottom of your zūmo into the
cradle.
7. Tilt the zūmo back until it snaps into
place.
8. Plug the other end of the automotive
power cable into a power outlet in your
car.
9. If you are using a traffic receiver in
Europe, secure the antenna on the traffic
receiver to the windshield using the
suction cups.
Warning: This product contains a lithium-
ion battery. To prevent damage, remove the
unit from the vehicle when exiting or store it
out of direct sunlight.
zūmo 600 Series Owner's Manual